How to make sch40 astm a511 mt304 seamless stainless steel pipe into cone analysis
Conical sch40 astm a511 mt304 seamless stainless steel pipe is also called large and small head/cone, which is widely used in hoppers, funnels, chimneys, mixing barrels, dust removal equipment and other products. It is a relatively simple sheet metal technology. step:
1. Stakeout of tapered sch40 astm a511 mt304 seamless stainless steel pipe: the tapered pipe is a fan-shaped expansion drawing, which can be staked out by hand (drawn on a flat steel plate) and computer.
2. Tapered sch40 astm a511 mt304 seamless stainless steel pipe cutting: The tapered pipe cutting is to cut the fan-shaped lines on the steel plate or use the fan-shaped lines drawn on the CNC cutting computer. Now most of them use CNC cutting to cut materials, mainly because the precision and speed are higher than manual ones.
3. Processing of tapered sch40 astm a511 mt304 seamless stainless steel pipe: the last step is to roll the fan shape through a plate rolling machine, and finally weld the gap to form. Note that some large-sized tapered tubes need to be divided into multiple pieces and then rolled because the width of the steel plate is not enough.
After understanding the processing process of tapered sch40 astm a511 mt304 seamless stainless steel pipe, look at the processing process of iron pipe.
The correct name of sch40 astm a511 mt304 seamless stainless steel pipe should be steel pipe. Compared with tapered pipe, the processing of steel pipe is much simpler.
1. Steel pipe cutting: Use a shearing machine to cut the steel plate into a square shape.
2. Steel pipe processing: put the steel plate into the plate rolling machine, and roll it into the steel pipe through the plate rolling machine.
How to make sch40 astm a511 mt304 seamless stainless steel pipe into a tapered summary?
Through the above analysis, it is not difficult to find that the conical tube is fan-shaped and the iron tube is rectangular. If the two have to change the rectangle into a fan-shaped, it will cost a lot of money.
sch40 astm a511 mt304 seamless stainless steel pipe is tapered. Specific processing steps:
Cutting the iron pipe -> flattening the iron pipe -> lofting -> blanking -> coiling -> forming
We do not recommend customers to change the iron pipe to a tapered pipe for the following reasons:
1. During multiple processing, the mechanical properties of the steel plate may change.
2. The processing process is cumbersome and the processing fee is too high. It is better to buy a conical tube.
If you have to change, please pay attention to the following details
1. The steel plate should not be too thick. Too thick steel plate is easy to break and deform after repeated processing. It is recommended that the thickness of the steel plate should not exceed 6mm.
2. The size of the fan-shaped figure set out by the tapered sch40 astm a511 mt304 seamless stainless steel pipe should preferably be smaller than the size of the expanded figure of the iron pipe, so as to avoid multiple splicing.
3. The diameter of the tapered sch40 astm a511 mt304 seamless stainless steel pipe should not be too small, and the minimum diameter of the coil can be rolled. If it is lower than this value, the lower part will be bent by a bending machine.