Precautions for using 304 stainless steel plate

304 stainless steel plate specifications are 1000mm, 1220mm, 1250mm, 1500mm, 1800mm, 2000mm. Widths above 3mm are generally 1245mm, 1500mm, 1530mm, 1800mm, 2000mm, and the length is not limited. The normal length is 6000mm, which can be customized.

Physical properties: tensile strength ≥520mpa, conditional yield strength ≥205mpa, area shrinkage ≥60%, specific heat capacity 0.5kj*kg, expansion coefficient 18.4, resistivity 0.73, longitudinal elastic modulus 193, thermal conductivity 21.5, hardness ≤ 187hb, ≤90hrb, ≤200hv, elongation ≥40%, density 7.93g/cm3, temperature resistance 800°.

Precautions for using 304 stainless steel plate

After the installation of the 304 stainless steel plate is completed, the film needs to be peeled off in time. Afterwards, the steel plate must also be cleaned with special stainless steel detergent. The commonly used method is to wipe it with talc powder (Shuangfei powder) from beginning to end, and then wipe it with clean water as much as possible. It needs to be wiped clean. The reason for tearing off the film in time is to avoid glue left for a long time or severe glue aging.

After the 304 stainless steel plate is installed, the plastic film can be peeled off immediately to deal with surface problems in time to prevent pollutants or corrosive liquids from penetrating into the tape, leaving the surface in a wet and cold corrosion environment for a long time, causing serious corrosion to the surface.