Do you know the process characteristics of 304 Austenite 2mm 304 stainless steel plate? The process characteristics are mainly reflected in oil grinding wire drawing, dry grinding wire drawing, 8K processing and titanium gold. The following is a detailed introduction.
1. Oil mill wire drawing
304 series stainless steel has perfect decorative effect after oil grinding, and is widely used in elevators, home appliances and other decorative panels. Cold rolled 304 series stainless steel can generally achieve good results after a single grinding. There are some machining centers on the market today that can provide oil-based frosting of hot-rolled stainless steel with an effect comparable to that of a cold-rolled oil mill. Oily stretching is also divided into filament and short filament. Elevator decoration generally uses filament, and various small household appliances, kitchen utensils and other lines are available.
2. Dry grinding and drawing
The common filaments and short filaments on the market, after being processed by stainless steel such as 316 stainless steel plate, show a good decorative effect, which can meet the requirements of general decorative materials. In general, 304 series stainless steel will form a good result after a single scrubbing. Because this kind of processing equipment has low cost, simple operation, low processing cost, and is widely used, it has become a necessary equipment for machining centers. Therefore, most machining centers can provide grinding plates with fine wires and short wires, of which 304 steel accounts for more than 80%.
3. 8K processing
In 8K processing, 304 series stainless steel is significantly better than 200 series stainless steel. 8K grinding of the 2B cold rolled surface, usually a mirror finish is achieved after one pass. At present, the 8K grinding process using nitric acid and red iron oxide is cheap, the cost of the value equipment itself is low, and the overall grinding cost is low, and it is widely promoted.
4. Titanium
The choice of high-end decorative materials has a gorgeous effect. 304 series stainless steel has long been used for titanium trim and is widely used in elevators and building trim.